I was working in a Customers Plant when I noticed a Guy coming around and inspecting the Fire Extinguishers .
normally I see the technician hold the extinguisher and tap it to loosen the powder and keepit fluffed and then you see them take off the hose and either blow thru it with air duster or look thru or run a thin piece of wire thru to make sure there not obstructed but thats not what I saw in this plant.
He simply tilted it looked in end of hose dusted off and tagged it inspected what we call in the Industry a RAG and TAGGER.
When I question his technique he says what he is ding is perfectly fine and then I find out he is the Fire Marshal for several community's. He even rides around in what looks like an official Fire dept looking vehicle which says Fire Prevention on it.
The whole situation is Bad you have some one who is suppose to be protecting people and he is not doing his job. I have consulted with several industry experts including Master degree Safety Personnel and they all agree in an environment like a fabricating shop with temperature extremes and dust everywhere . He should have done a more complete job at what he was doing . He should have done a better job to make sure powder was loose and hose was not obstructed. He said he was worried rust on units when he hit them to loosen powder would effect them then he should have replaced them if they are showing rust. Its right in OSHA Regulations they are to be replaced if rusted and in a fabricating shop not only NFPA applies but OSHA rules over everything.
Of course the next question should a person like a Fire Marshal even be doing this kind of work and that even includes installing fire alarms, selling smoke detectors, first aid kits etc.
OK well he is not doing so in community's he protects but it still leaves the door open to ethics and power the fire Marshal has
If your not going to do a job properly you should not be doing it period.
If I am questioning what he is doing I am sure others are as well.
No comments:
Post a Comment