Monday, April 16, 2018

Motion Sensors Another case of Green Technology Wasting Energy .

One of my customers has a large warehouse where they store oil products and Forklifts are used to shuttle items around and into and out of trucks.

The electrical outfit they hired to install the new lighting  to save energy put in the Energy Code required motion sensors on the new T8 fluorescent light fixtures which are designed to shut the lights off to save energy but in the long run they have cost energy because they where set too low a time on which turns the fluorescent bulbs on many times a day and shortens their lives.
I have had to change the bulbs at least 6 times in the warehouse compared to warehouse down street
where same exact lights have not ben changed. thats a major waste of energy all those bulbs being made and life shortened

The reason is fluorescent bulbs are designed to only operate for so many cycles due to surge of power which turns them on the timers where set for in some cases only 1 minute which means every time
a fork lift operator came by the lights tuned on and off in some cases up to 50 or more times a day
and since the bulbs only have a cycle rating of  5000-7000 times on and off  poof bulbs needed changed every 3-4 months . I have since changed them up to max allowed 30 minutes in high use areas and now lights turn on maybe 6-8 times a day and bulbs are lasting much longer. and in long run staying on longer saves more power than constant on and off surging of the power. .

Once again Green Technology has proven to be a waste because there where no instructions  to set timers to type of lighting and the union electrical outfit that did the work could care less how or why they did the work. which is a shame most time union electrical work is excellent this company's work was sub par.

No comments:

Post a Comment